Difference between revisions of "Installing Elsewhere"

From Hyrel3D
Jump to: navigation, search
(My Unit Shipped with a Motherboard)
(Installing on Another Computer)
Line 7: Line 7:
 
=== Installing on Another Computer ===
 
=== Installing on Another Computer ===
  
We run the current Repetrel on Windows 7, 8 and 10 on both Intel and AMD processors; however, you may not be able to run the printer from every unique environment possible. Please know that we cannot help troubleshoot every unique environment - this is why we include a full Tablet PC with each printer. These instructions work for most external installs:
+
Note that all Hydra and EHR models have the new tablet interface boards, and no jumpers are required.
 +
 
 +
We run versions of Repetrel on Windows 7, 8 and 10 on both Intel and AMD processors; however, you may not be able to run the printer from every unique environment possible. Please know that we cannot help troubleshoot every unique environment - this is why we include a full Tablet PC with each printer. These instructions work for most external installs:
  
 
# Install Repetrel, as per side menu under Software and Firmware.
 
# Install Repetrel, as per side menu under Software and Firmware.

Revision as of 13:29, 5 October 2018

Installing on Another Computer

Note that all Hydra and EHR models have the new tablet interface boards, and no jumpers are required.

We run versions of Repetrel on Windows 7, 8 and 10 on both Intel and AMD processors; however, you may not be able to run the printer from every unique environment possible. Please know that we cannot help troubleshoot every unique environment - this is why we include a full Tablet PC with each printer. These instructions work for most external installs:

  1. Install Repetrel, as per side menu under Software and Firmware.
  2. Install Drivers.
  3. Install Ecosystem Apps.
  4. Navigate to C:\EcosystemApps\Slic3r\slic3r.exe and execute it from the windows browser BEFORE LAUNCHING Repetrel.
    1. Go to File > Preferences and set the Mode to Expert, check all four boxes, and click OK. Then close Slic3r and launch Repetrel.

My 30M/ESR Shipped with a Tablet

1. Don't worry about ever powering up the tablet - you can remove it. We just want the 3.3v, 5v and 12v power and USB connectivity to the spine and beyond.

2. Install the software as shown at Repetrel above, and Ecosystem Apps below.

3. Install the drivers as shown at Drivers above.

4. Unplug the cables for the tablet USB connectivity and install PC Jumpers as shown:

USB: Tablet Interface Board Changes for USBB Control

See the video.

5. Run a USB A to B cable from your PC to the USB-B port on the left side of the Printer:

USB: Left side of Printer


My 30M/ESR Shipped with a Motherboard

1. Don't worry about ever powering up the motherboard. We just want the 3.3v, 5v and 12v power to the spine and beyond.

2. Install the software as shown at Repetrel above, and Ecosystem Apps below.

3. Install the drivers as shown at Drivers above.

4. Run a USB to MiniUSB cable from your PC to the MiniUSB port on the right side of the Spine:

USB: Lower Right Spine

5. Run a USB to MiniUSB cable from your PC to the MiniUSB port on the top, inside of the Spine:

USB: Top Inside Spine