Difference between revisions of "Gcode"
(Created page with "Category:HowTo {| align="right" | __TOC__ |} Everything your Hyrel 3D Printer does is done by executing GCode, whether you are aware of it or not. Below, I will explain ...") |
|||
| Line 8: | Line 8: | ||
Below, I will explain those gcodes about which we get the most questions. | Below, I will explain those gcodes about which we get the most questions. | ||
| − | == | + | == '''Movement''' == |
There are two primary movement commands: G0 and G1, and are thus explained: | There are two primary movement commands: G0 and G1, and are thus explained: | ||
Revision as of 18:23, 17 November 2016
Contents |
Everything your Hyrel 3D Printer does is done by executing GCode, whether you are aware of it or not.
Below, I will explain those gcodes about which we get the most questions.
Movement
There are two primary movement commands: G0 and G1, and are thus explained:
G0
G0 is a rapid positioning move. It is not a working move, meaning that your equipment will not be printing, milling, lasering, or doing any other active work during a G0 move. G0 is intended to move your tool to a new position, where the work will happen. Accordingly, G0 movement speeds are normally set to a maximum on your equipment, via your configuration settings, rather than being specified in your gcode file.
